The height should be about one and a half times the width of the container, not
less, but if it is fine material it may be more. The other two pieces should be
placed one on each side of one close to the first, Five or six Irises or Tulips
may now be placed in front of the leaves, graduated in height and not
immediately one below the other, but slightly “Staggered”. A bud should be at
the top and the largest flower low at the base to be the center of interest. If
Tulips are used, the petals of the lowest ones may be turned back carefully to
appear more important. Large leaves such as Bergenia, Laurel or Arum are needed
to give weight to the base, not forgetting to put one or two at the back of the
pin holder to give depth to the arrangement. florist manila delivery in USA with the help of philippinesflowersdelivery.com/
Some feeling in the material can be recessed round the lower flowers. This design can be made in a tall narrow container, but this is more difficult for a beginner.
A simple triangular arrangement requires three pieces of fine foliage, one for the center upright and the other two pieces for the “arms,” about two-thirds the length of the main branch. This should be placed horizontally on each side, but coming slightly forward in order to give depth to the arrangement. To place them at an angle on the pin holder, cut the stems at a slant, put them upright on the pins and press them down to the desired position. Imagine a triangle with the three points of the outline and all other material should be within this to keep the design. Working towards the center, still with all the stems flowing out from the point, fill in with medium flowers and foliage, which should be directly beneath the tallest placement. Do not forget to make some flowers and foliage flow forwards and recess others to give the arrangement a third dimension. This design can also be used in a pedestal type container when the height of the container governs the length of the main branch. This should be one and a half times the length of the container, plus enough stem to go down into the water. Always remember to allow some flowers and foliage to flow over the rim of the container. An asymmetrical triangle is made in the same way.
Some feeling in the material can be recessed round the lower flowers. This design can be made in a tall narrow container, but this is more difficult for a beginner.
A simple triangular arrangement requires three pieces of fine foliage, one for the center upright and the other two pieces for the “arms,” about two-thirds the length of the main branch. This should be placed horizontally on each side, but coming slightly forward in order to give depth to the arrangement. To place them at an angle on the pin holder, cut the stems at a slant, put them upright on the pins and press them down to the desired position. Imagine a triangle with the three points of the outline and all other material should be within this to keep the design. Working towards the center, still with all the stems flowing out from the point, fill in with medium flowers and foliage, which should be directly beneath the tallest placement. Do not forget to make some flowers and foliage flow forwards and recess others to give the arrangement a third dimension. This design can also be used in a pedestal type container when the height of the container governs the length of the main branch. This should be one and a half times the length of the container, plus enough stem to go down into the water. Always remember to allow some flowers and foliage to flow over the rim of the container. An asymmetrical triangle is made in the same way.
No comments:
Post a Comment